Ionized grout powder
Category : Grout powders
- Features Compatibility with all kinds of plastic and acrylic paint
- Quality : Improved (ionized)
- Thickness : 1 – 3 mm
- Weight : 2kg | 5kg | 20kg
- Physical mode : Powder
- Color : White

RJ 900 Grout powders
Category : High-grout powder
Quality :
Transfer speed :
Costumer service :
- Quality : Improved (ionized)
- Weight : 1.32 gr/cm3
- Physical mode : Powder
- Color : Gray
- Chloride ion Not used:


Producer : Romolo
Function : 5 / 5 Customer satisfaction rate


Quality authenticity guarantee

Ionized RJ900 grout powder
Category : High-grout powder
Quality :
Transfer speed :
Costumer service :
- Quality : Improved (ionized)
- Weight : 1.32 gr/cm3
- Physical mode : Powder
- Color : Gray
- Chloride ion Not used:

Producer : Romolo
Function : 5 / 5 Customer satisfaction rate

Quality authenticity guarantee











Physical and chemical properties | |
SPECIAL WEIGHT |
1.32 gr/cm3 |
Color | Gray |
Physical mode | Powder |
PH | 7 – 8 |
Chloride Ion | Not Used |
APPLICATION :
Suitable for slurry sealing base plates
Suitable for slurry sealing the foundation of machines
Suitable for slurry sealing Anchorage
Suitable for filling remaining holes in concrete
Suitable for filling the remained holes in dynamical base plates
HOW TO USE :
The place which we tend to use must be clean. for each KG of grout, you should use about 150 to 200c 20 degrees (c) water. First, pour the water then slowly add the grout. Avoid stirring the compound too fast. The less water you use the stronger the compound will get.
CAUTION : Be precise while measuring the water to grout ratio. Bolt holes most be fairly clean. If the grout is intended to be used in construction frameworks, the frameworks must be tight so the grout does not leak. Slurry sealing must be done from one way it doesn’t trap any oxygen. The plates should have about 5cm of free space around it so it prevents any damage from longitudinal expansion. The place in which you want to use the grout should be at least 15 cm deep. For more strength in both grout and concrete, it is advised to use Romolo’s concrete adhesive instead of water ( mix 1 lit of concrete bonding with 5 lit of water then add it to the grout) It is advisable to make the surface in which you want to use the grout wet a few hours prior to the work. but it is extremely important to dry all the surfaces and all the holes on or under it from the water before you start the work. For a normal surface, the slurry sealing should not have a width of more than 5 cm. If you wish to seal more than 15cm wide you should use sand in which the grains are about 3 to 14mml wide which for different builds needs a different ratio of sand to grout but the ratio should never be higher than 1.
PACKING :
Romolo’s RJ900 is available in 25kg bags
HOW TO MAINTAIN :
Suitable temperature for maintaining waterproof powder is 5-25° C The shelf life of the product is 12 months in the original and unopened packaging. Keep away from direct sunlight, cold, extreme heat, and frost
SAFTEY :
Avoid direct contact with eyes and skin, wear gloves, glasses, and appropriate clothing during the run. In case of contact with eyes, rinse immediately with lukewarm water for 15 minutes.