APPLICATION :

Installation on plaster, cement, tile, glass surfaces

Installation of all kinds of Stone, plastic, and platform

Installation of all variety of tile, ceramic and antique stone

Installation on a variety of clay Surfaces and wood surfaces

Installation of all kinds of Interior and exterior decorative bricks

Installation on concrete surfaces, prefabricated parts, panel paste tile on old tile

Installation of concrete panels

HOW TO USE :

Clean the surface from any contamination and dust then create a few lines on the surface by using a milling stone then apply the paste adhesive on the wall with a needle knife (The maximum thickness is 3-4 mm per square meter) after 3-5 minutes Stick the soaked tile to the surface, after 12-24 hours, wall tiles reach their ultimate strength and after this time you can start bonding, the Suitable temperature for installation tile adhesive is 5-25 ° C.

CauionThe amount of adhesive used depends on the type of substrate and how the bumps behind the ceramic tile, typically 3-4 kg is sufficient per square meter.

PACKING :

Romolo tile adhesive is available in 1, 5, 12.5 and 25kg buckets.

HOW TO MAINTAIN :

Suitable temperature for maintaining waterproof powder is 5-25° C The shelf life of the product is 12 months in the original and unopened packaging. Keep away from direct sunlight, cold, extreme heat, and frost

SAFTEY :

Avoid direct contact with eyes and skin, wear gloves, glasses, and appropriate clothing during the run. In case of contact with eyes, rinse immediately with lukewarm water for 15 minutes.