Romolo ionized block adhesive is a product based on synthetic polymers, mineral micronized powders and waterproofing compounds formulated with ionization technology. This product is ready to use and has very strong adhesion to all types of surfaces and building materials.


Properties
Special Weight 2.1gr/cm3
Physical mode Liquid
PH 14
Color White


Download Datasheet



Products Specifications

Romolo ionized block adhesive is a product based on synthetic polymers, mineral micronized powders and waterproofing compounds formulated with ionization technology. This product is ready to use and has very strong adhesion to all types of surfaces and building materials.

In order to check some of the unique features of this product, we can refer to facing materials: Fast setting and hardening after application. Waterproof and insoluble in water after drying. Ease of installation and saving time and money. Very good flexibility against cracking or falling of the block. Very high resistance to moisture, steam, acid and oil. Strength against building movements (vibration, contraction, expansion).

Application

Suitable for gluing all kinds of cement blocks,Heblex blocks,Lika blocks and all kinds of blocks. Suitable for installing all types of interior and exterior decorative bricks, suitable for installation on all types of clay and wooden surfaces. Suitable for installation on all types of plaster, cement, tile, glass, stone, plastic and plastofoam surfaces. Suitable for installation on concrete surfaces, prefabricated parts and panels.

How to use

To stick different types of blocks : clean the work surface from any kind of dirt and grease, after stacking each row of blocks, seal all the seams from the sides with Romolo block adhesive. Each kilogram of Romolo block adhesive is enough to install one square meter.

To install different types of tiles: clean the surface below of any dirt and grease and create a few lines on the desired surface with an ax or grinding stone, then apply Romolo block adhesive with a combed trowel to a maximum area of ​​one square meter and a thickness of 4 – 3 mm on the wall and stick the wet tile on the surface within 3 – 5 minutes. The suitable temperature for installing Romolo block adhesive is 5 – 25 degrees Celsius.

The consumption amount of Romolo block adhesive depends on the type of surface under work and the type of seams and is usually equal to one kilogram per square meter.

Packing

Romolo ionized block adhesive is produced and supplied in 12kg buckets.